Door Axis 10 in x 34 in Aluminum Commercial Kick Plate
Reviewed pricing, lead time, freight, and final configuration are confirmed during quote review before order release.
The Door Axis 10 in x 34 in Commercial Kick Plate shields the lower face of high-traffic doors with a aluminum panel sized for 36 in commercial openings. It serves offices, schools, and storefronts that need code-conscious door protection with a finished look.
The plate is cut from 16 gauge stock with a aluminum face and square-cut, non-beveled edges for a clean commercial line. Mounting is surface-applied with the included sheet metal screws, and the pattern conforms to ANSI J405 and A117.3 so it can be specified on accessibility-reviewed openings. At 10 in tall it covers the full kick zone against carts, feet, and floor equipment on a standard commercial door.
Highlights
- 10 in x 34 in coverage for 36 in commercial doors
- Satin aluminum face
- 16 gauge plate stock
- Square-cut edges, not beveled
- Surface mount with included sheet metal screws
Specification Table
| Function | Commercial kick plate |
| Plate size | 10 x 34 in |
| Thickness | 16 gauge |
| Material | Aluminum, 16 gauge |
| Finish | Aluminum |
| Edges | Square cut, not beveled |
| Mounting | Surface mount, screws included |
| Pack | 1 plate |
| Application | Commercial doors |
Included Components
- One aluminum kick plate
- Sheet metal mounting screws
Installation Notes
- Center the plate on the push side with equal reveals; keep the bottom edge just above the floor line or door sweep.
- Pre-drill pilot holes in metal-clad doors before driving the sheet metal screws.
- Plate width runs about 2 in less than door width so hinge and latch edges stay clear.
- Verify local accessibility requirements for plate height before installation.
Warranty and Support
- Coverage confirmed during quote review.
Frequently Asked Questions
What door width does the 34 in plate fit?
A 36 in commercial door. Kick plates run about 2 in narrower than the slab so the edges clear the stops; other widths are quoted on request.
Is the plate beveled?
No. The edges are square cut per the commercial pattern, which sits tight to the door face under a surface mount.
Is a brass finish available?
The same plate runs in a brass plated version on the supplying line; it is quoted on request.
Documents
- Type Kick Plate
- SKU DA-DR-HW-KPL-CMB
Download the available product documents below. If a document is not linked yet, use the SKU during quote review.
Project pricing, lead time, freight routing, and final configuration are confirmed during quote review before order release.
Support and request quote workflows stay available throughout specification and order planning.