Namimera Electric Bidet Seat for Elongated Toilets with Heated Seat and Warm Air Dryer, White

This designer-ready product summary covers an elongated electric bidet seat with a stainless steel three-in-one nozzle, 5-level pressure and 4-level water temperature control, heated seat with occupancy sensor, warm air dryer, night light, and 120V 870W max draw on a 15 Amp GFCI outlet, helping bath programs move from review to release with fewer scope gaps.

Highlights

• Warm-water rear wash, front wash, and turbo spray from a retracting stainless steel nozzle
• 5-level wash pressure and 4-level water temperature control from the side panel
• Adjustable heated seat with occupied-seat sensor that enables wash functions only when seated
• Warm air dryer reduces paper use
• Slow-closing seat and lid with built-in night light
• Installs on most elongated one-piece and two-piece toilets with the included 7/8 in. T-valve
• 120V, 870W maximum draw; requires a grounded 15 Amp GFCI outlet within 4 ft.
• Power-saving mode plus thermal fuse and safety sensor protection

Specification Table

Included Equipment

• Electric bidet seat with side control panel
• Catch plate mounting bracket with top-mount bolts and rubber nuts
• 7/8 in. T-valve with washers
• Bidet water supply hose
• Installation and owner guide

Installation Notes

• Confirm an elongated bowl before ordering: measure from the seat-bolt centerline to the front rim, about 18.5 in. for elongated bowls.
• A grounded 15 Amp GFCI outlet is required within reach of the 4 ft. cord, ideally at least 1 ft. above the floor; do not use extension cords.
• Shut off the supply stop, install the 7/8 in. T-valve at the tank inlet, and route the included hose to the seat inlet; check for leaks before first use.
• Electrical work, if a new outlet is needed, should be completed by a licensed electrician.
• Review the final fit verification and accessory bundle during quote review before order release.

Warranty and Support

• Published warranty coverage: one-year warranty on the bidet seat
• Replacement nozzles, T-valves, and hoses are supported through quote review
• Final warranty registration and coverage documents are confirmed during quote review

Frequently Asked Questions

Does it fit my toilet?
This record covers the elongated size, which fits most one-piece and two-piece elongated toilets. Measure from the seat-bolt centerline to the front rim before ordering; fit is confirmed during quote review.

Does it need a dedicated electrical circuit?
The published specification summary calls for a grounded 15 Amp GFCI outlet on 120V service with a maximum draw of 870W. Local electrical code questions are confirmed during quote review.

Is the water instantly warm?
An 800W heater warms wash water on demand with four temperature settings, and the occupancy sensor keeps heating idle when the seat is empty.

Can a homeowner install it?
Yes, when an outlet already exists: the seat mounts from the top of the bowl and the included T-valve tees into the existing toilet supply without soldering.

Documents

• Product Submittal Summary (PDF)
• Dimensional & Fit Reference (PDF)
• Installation & Warranty Reference (PDF)

Project pricing, lead time, freight routing, and final configuration are confirmed during quote review before order release.

Support and request quote workflows stay available throughout specification and order planning.