Spectre Window 40 in. x 17 in. Window Well Cover
Reviewed pricing, lead time, freight, and final configuration are confirmed during quote review before order release.
Every cover is molded from impact resistant plastic in a clear or translucent panel that keeps basement daylight while shedding debris. Flat and low profile covers sit tight to grade for walkway edges, standard and sloped profiles shed water away from the foundation, the dome profile clears deeper wells and taller windows, and a ventilated 39 in. x 13 in. profile keeps air moving for vents and dryer terminations. Fastening is by screws or spring clips depending on profile, and each size is matched to the well footprint it caps, including the companion well and area wall program. Covers over emergency escape and rescue openings must stay removable from inside without tools; flag those openings during quote review.
Highlights
- Eleven stocked profiles: flat, low profile, standard, sloped, ventilated, round, and dome
- Impact resistant plastic keeps daylight passing while debris stays out
- Sized to cap well footprints from 35.5 to 48 in. wide
- Sloped profiles shed water away from the foundation
- Ventilated profile for vent wells and air flow
- Screw or spring clip fastening by profile
Specification Table
| Flagship size | 40 in. x 17 in. dome |
| Stocked footprints | 35.5 x 16.5 to 48 x 22 in., plus 44 x 25 and 45 x 26 in. |
| Profiles | Flat, low profile, standard, sloped, ventilated, round flat, dome |
| Material | Impact resistant plastic |
| Panel | Clear or translucent; finish varies by profile |
| Mounting | Screws or spring clips depending on profile |
| Ventilation | Ventilated profile in the 39 x 13 in. size |
| Egress note | Covers over escape openings must remain removable from inside |
| Installation | Surface mount over the well rim |
| Weight | About 5 lb flagship size; varies by profile (engineering estimate) |
| Warranty | Limited manufacturer backed warranty program, confirmed during quote review |
Included Equipment
- Molded well cover
- Fastener pack (screws or spring clips) on profiles noted during quote review
Installation Notes
- Measure the well width and projection at the rim and match the cover footprint before ordering; the cover should overlap the rim on all sides.
- Seat the cover on the well rim and against the foundation wall, then fasten with the screws or spring clips supplied for the profile.
- Keep covers over emergency escape and rescue openings removable from inside without tools or keys.
- Clear leaves and snow load periodically; sloped and dome profiles shed best when the surrounding grade stays lower than the rim.
Warranty and Support
- Warranty coverage is confirmed during quote review before release.
- Quote packages include sizing review against the window opening and grade conditions.
Frequently Asked Questions
How do I size a cover to my well?
Measure the outside width of the well and its projection from the foundation at the rim. Pick the cover footprint that overlaps both dimensions; share the measurements during quote review for confirmation.
Will a cover block daylight to the basement?
No. The panels are clear or translucent impact resistant plastic, so wells keep passing daylight with the cover in place.
Are these safe over egress wells?
Covers over emergency escape and rescue openings must stay removable from inside without tools. Flag egress openings during quote review so the right profile and fastening are specified.
Which profiles include fasteners?
Screw and spring clip packs ship with the profiles that use them; the fastening method for each size is confirmed during quote review.
Documents
- Type Window Accessory
- SKU SW-WIN-ACC-WELLCVR-4017D
Download the available product documents below. If a document is not linked yet, use the SKU during quote review.
Project pricing, lead time, freight routing, and final configuration are confirmed during quote review before order release.
Support and request quote workflows stay available throughout specification and order planning.